Weihrauch HW100/HW101 air cylinder tool
This tool can be used to remove the ends from a HW100/HW101 air cylinder. You can use a 38mm/adjustable spanner/wrench or an 8mm round bar for leverage, while the air cylinder is clamped tightly in a vice with protective jaws.
The tool is ideal if you need to get the ends out of the air cylinder (which can be very tight) to carry out a service or repair a leaky fill valve. It is also handy for people who have bought an aftermarket cylinder, which need the original cylinder ends swapping over to the new air cylinder.
The tool is made from steel, it is not stainless steel, so it will need to be kept dry and oiled if you do not want it to rust.
Please use the tool at your own risk, if used properly it will gives years of trouble free service, if used improperly it may damage the finish on your air cylinder.
The tools shown in the photos are for reference only, you are buying the hex tool that fits onto the ends of the air cylinder, nothing else.
This video shows the tool being used >>here<<