S200/CZ 200 Firing/filling valve removal tool - Hex

00170 HEX

This is a handy tool to help you remove the ends of your Air Arms S200 (CZ) air cylinder.

You can use this tool when you need to remove the original gauge/quick fill to replace your O rings and/or to fit an XTX pressure gauge and quick fill.

You can also use this tool to remove the firing valve end from the air cylinder if you want to replace your O rings and/or to fit a HuMa S200 regulator.

The tool has been machined out of aluminium (which is relatively soft, so that it does not mark or damage your air cylinder finish) to fit over the air cylinder, it has locating holes and pins (supplied) that fit into the holes in the ends of your cylinder. Once the pins have been fitted you can then either clamp the tool in a vice or use a large adjustable spanner etc and unscrew the ends of the cylinder. The flats on the tool measure around 35.1mm or 1.38". There is also a round version of this tool in the eShop.

If you do get some silvery marks on the air cylinder from the soft aluminium tool you should be able to rub them off using an oily rag or oily toothbrush.

There is a video on the XTXair YouTube channel showing the S200 tool in action click here

Please note that because it is made of aluminium this is not a heavy duty/trade tool, it is suitable for the home tuner, it will not last long if being used on multiple rifles.

View Product Video

Earn 0 reward points
£6.50 £8.50
Out Of Stock
Add To Wishlist

Want to be notified when this product is back in stock? Complete the form below and we'll send you an email when it is.

The item has been added to your basket

Continue Shopping
Proceed To Checkout