Shroud/Bullbarrel - Huub - 12" Barrel Version
This is for a shroud or bullbarrel made by Huub in the Netherlands.
They will fit BSA PCP rifles that have a 12" barrel like the very early R-10 and R-10 Ultra Carbine, Ultra MMC and Ultra SE but not the very early low breech single shot rifles. Barrels are measured from the breech (magazine slot) to the tip of the muzzle. 12" BSA barrels usually have 3" inside the breech block and 9" sticking out of the breech block.
They are made from aluminium, which is then sand blasted and powder coated black which gives it a nice textured matt finish.
They extend roughly 140mm (5.5") past the end of the barrel as standard, they are roughly 370mm (14.6") long overall, they are 27mm outside diameter and contain baffles and a reflex bush that allows that area over the barrel to be used as an expansion chamber (which makes them quieter). There is no provision for an additional/external silencer/moderator but you should not need one because the shroud is very effective at quietening the muzzle report.
A rifle barrel length is measured from the breech (where the pellet goes into the barrel - magazine slot on a BSA) to the muzzle (where the pellet comes out, excluding any silencers/strippers/muzzle weights etc). How to measure your barrel length video >here<
If you have a 15" or 18.5" barrel please see the other shroud options in the eShop.
If you have a single shot rifle and you would prefer a shroud without the magazine catch cutout please get in touch, I can special order one for you.
The shroud comes with the shroud tube, adaptor to fit it to the barrel, internal baffles, rollers, wadding material and the reflex/backflow bush. The rollers and wadding can be cut to different sizes to allow you to experiment with different chamber lengths, to get the "volume" you like most. There are no paper fitting instructions posted out with the shroud, the fitting instructions are >> fitting instructions << and can be found on the shrouds page on this website. There is a YouTube video on the XTXair channel that shows how to fit the shroud Fitting video
PLEASE NOTE: This version is only for barrels that are threaded for a silencer, the thread is needed to allow the reflex adaptor to screw onto the barrel. A version for non-threaded barrels is not currently available.
The rifles in the pictures are shown for illustration only, you are paying for a shroud, not a rifle.
Regular price £95.00 Sale price £90.00