Cylinder Clamp 28mm - Plastic

XTX Air
CLAMP 28P

This is a handy tool to help you clamp the air cylinder of your S200/CZ 200 or BSA PCP. It is used to clamp the cylinder so that you can unscrew the ends (fill valve body, firing valve or regulator) because they can be very tight. They are useful for servicing your rifle and also when you want to fit a regulator.

It is not suitable for the Air Arms S400, S410, S510, EV2, TDR, FTP900, Ultimate Sporter air cylinder, I have different tools for these in the eShop.

The tool has plastic faces to reduce the risk of marking or damaging your air cylinder, it has 2 bolts for tightening the collet to your air cylinder, you will need a 10mm spanner/wrench to tighten/loosen the bolts. Once the collet has been secured to your air cylinder you can then clamp the tool in a vice or use a large adjustable spanner etc and unscrew the ends of the cylinder. 

If you don't tighten it enough there is a chance it will slip on the cylinder, which can damage the blued finish. Also make sure you tighten it onto the cylinder where there is internal support i.e over the fill valve body or firing valve body, to avoid crushing/damaging the air cylinder.

Use it at your own risk!

Earn 0 reward points
£0.00 £8.00
QTY:
Out Of Stock
Add To Wishlist

Want to be notified when this product is back in stock? Complete the form below and we'll send you an email when it is.

The item has been added to your basket

Continue Shopping
Proceed To Checkout